On the mnaual, I dont mind the Stop-Start, as its easy to control. But on a DSG I would be very keen to try this. As when driven various Auto's with Stop/Start it bordered on dangerious when the car cuts out while waiting in a juntion etc. VW Polo, MY2018 - start/stop permanent deactivationNew cars usually have stop/start system, which on stops disables the engine and saves fuel. You can tempor Disconnect the lowest connector which is for Auto Start-Stop button. This will automatically put the system in bypass mode – disabling the Auto Start-Stop function. Auto Start-Stop plug on white box under the steering wheel. Note: Your dealership may not like unplugged wires and make a fuss about it – so make sure to reconnect this wire There are ways to permanently disable it using VCDS or OBDeleven, along with having the dealership flash it for you. Bonus with VCDS or OBDeleven is there are a bunch of other tweaks that you can enable/modify. I have a 2019 Tiguan. If you leave it in 'snow' mode that will disable start/stop. For the sake of anyone in the vehicle, I suggest that you buy and fit one of THESE. Or you could pay more and buy one of THESE .The Kufatec unit simply plugs into the OBD port (one time only). It's self programming and you can restore SS by re-pluging the dongle again. Don. Once you have located the OBD2 port, turn the ignition but do NOT switch the car on. Put the plugin into the OBD2 port and wait for the main screen to "reboot." Once this has happened, the green light will be off and the ECO start/stop function will be disabled. The ECO stop/start function will remain available, however, should you wish to use subtract 4 to the value --> Start&Stop always disabled. add 32 to the value --> remember last status. - test & save. In addition of these values, if you add 64 to the value, the Start & Stop button light will be reversed: off if Start & Stop is disabled, and on if Start & Stop is enabled. My car original number is 28, and I changed it to 60. Connect the OBD II to the car. Turn the ignition to the ON position. Read the codes on the OBD and erase them. Remove the key and turn off the OBD. You should first disconnect the battery to avoid any damage to the ECU. Once you have access to the ECU, remove the check engine fuse for about a minute. You should then connect the battery and DqfdUH6.

how do i permanently disable start stop vw